DamenCNC - Stepper Drivers

Stepper Drivers

A listing of stepper drivers that can be supplied from stock. This is a selection of the total components that we can offer.
If you're looking for a component which isn't listed you can always send an email to me for an inquiry. When ordering in large quantities it is possible to negotiate a price.

HP 5042 4,2A 50V driver 1/128 microstep

This driver comes tested and assembled. Is great for the intermediate applications, driving motors up to 2nm. The most common use if for making routers. The driver is compatible with USBCNC, giving a very reliable and powerful system. Its also possible to use the driver with the interface kit offered in electronic parts...

Single Unit :	€ 54.61 (excl. tax)
Set of three :	€ 147.02 (excl. tax)
Set of four :	€ 193.24 (excl. tax)

HP 5056 5,6A 50V driver 1/128 microstep

This driver comes tested and assembled. Is great for the bigger applications. Converting a large lathe like an AI or a bridgeport mill is not uncommon for these drivers. The driver can be connected to the interface kit offered in electronic parts. Combination with 2amp and 4amp drivers is possible.

Set of 3 HP5056 Drivers :	€ 180.67 (excl. tax)
Set of 4 HP5056 Drivers :	€ 239.50 (excl. tax)
Single Unit HP5056 :	€ 63.03 (excl. tax)

HP 8078 7,8A 80V driver 1/256 microstep

Single Unit :	€ 89.99 (excl. tax)
Set of 3 :	€ 251.99 (excl. tax)
Set of 4 :	€ 335.99 (excl. tax)
HP 8078 L (new model) :	€ 87.99 (excl. tax)

VAC_220_78

This driver is the best performing stepper driver we can offer. Since it can operate up to 230V, the steppermotors will be able to run at very high velocity, giving very good performane, with NEMA 34 motors. Its recommended for large lathe and mill conversions.

VAC_220_78 Single Unit :	€ 172.26 (excl. tax)
VAC_220_78 Three Units :	€ 504.19 (excl. tax)
VAC_220_78 Four Units :	€ 668.90 (excl. tax)