| |
Ready to run In the past lots of request had come in if it was possible to receive a stepper set which was assembled tested and ready to go. All the kits that are offered here fulfill this demand. The packages only have to be plugged into the mains, the LPT cable hooked up, install software and of course a milling machine is needed to put the motors on. In the future a mach 2 configuration file will be supplied, which already setup for these motors. At the moment there is one available that has all the basic configurations correct but the motor tuning isn't correct.
| DCNC-RTR-Classic
This is a Ready to Run set for the bigger applications. With 4,5NM motors we us it to drive large routers 2x3meters. It also works perfectly to retrofit large mills and lathes. | DCNC-RTR-Classic : | € 1343.70 (excl. tax) |  | |
|
| DCNC-RTR-Economy
This is a Ready to Run set for the smaller applications. Only for use with 1NM or 2NM motors. | DCNC-RTR-Economy : | € 923.53 (excl. tax) | | |
|
| DCNC-RTR-Performance
This Ready to Run set intended for the business customer, that wishes to run a machine daily. The extended I/O makes running a production line/process possible. | DCNC-RTR-Performance : | € 1931.93 (excl. tax) | | |
|
|
| | | Your shopping |
|
| You have 0 item(s). | |
Your basket is empty. | |
|
|
