Previous article | Show list | Next article |
Driver Compatibility PCB M542 & ND556
Article number 1107
DamenCNC

€9,99
Excluded VAT
Price per piece
Configure your product
Description
USBCNC CPU V3 V4 and V5B use 10 pole ribbon cable (flat cable) to make connections to the stepper drives or servo drives. Since often mistakes were made here in wiring, we developed already a few years ago a small PCB that goes into the stepper drive. Then no wiring is needed anymore. All that is needed is a 10 pole ribbon cable between the USBCNC CPU and the stepperdrives. It will save you a lot of time and headache during wiring of your CNC controller. We offer here the PCB for the most common stepper/servo drivers. (note for CPU5A this system will only work if you buy the additional DamenCNC interface, the standard CPU5A uses an SUB-D connector.)
Component features:
- Compatible with USBCNC CPU V3 V4 V5B
- Designed for 5042 and 5056 drivers (leadshine 542 and 556 analog drivers)