Previous article | Show list | Next article |
M10 Counterbore Drill Ø18.0mm, pilot Ø10.5mm DIN 373 Fine (0214001800100)
Article number 5406
Maykestag
Limited stock
General conditions | ||
Quantity 5 - > | 10,00 % on the retail price of €52,99 | €47,69 |
Quantity 10 - > | 20,00 % on the retail price of €52,99 | €42,39 |
€52,99
Excluding VAT
Price per piece
Description
Discount
Compatible Products
Special drills used to make counterbores that are often required when using bolts that have a hex drive. Common in DIN912 bolts, but also DIN6912, and DIN794, and DIN 84. Before using this special drill, it's required to drill a pilot hole that matches the size of the guidance pin, on the drill. In the 2D dimensional drawing, it's the d1 dimension. In the compatible products tab, we also have a link to the correct drill, we advise for drilling the pilot hole.
Component features:
- Pilothole diameter d1: 10.50mm
- Counterbore diameter d2: 18.00mm
- Shaft/collet size d3: 12.50mm
- Total Length L1: 100.00mm
- Cutting edge length L2: 22.00mm
- Number of teeth Z: 3
- Maykestag part number : 2140018001
Price agreement
Below you will find you personal price agreements.
|
Single ER 20 Collet 1/2“ (12.70mm) Swiss Quality
In Stock
€27,00
Excluding VAT
Price per piece
Single ER 20 Collet 13.00mm Swiss Quality
€22,00
Excluding VAT
Price per piece
Single ER 25 Collet 1/2“ (12.70mm) Swiss Quality
In Stock
€28,50
Excluding VAT
Price per piece
Single ER 25 Collet 13.00mm Swiss Quality
€22,00
Excluding VAT
Price per piece
Single ER 32 Collet 1/2“ (12.70mm) Swiss Quality
In Stock
€29,00
Excluding VAT
Price per piece
Single ER 32 Collet 13.00mm Swiss Quality
€24,00
Excluding VAT
Price per piece
10,50 mm Jobber Drill DIN 338 (601010501)
€11,99
Excluding VAT
Price per piece