NEMA 34 12.0Nm stepper motor, but then with a double shaft. The double shaft is often used to mount a mechanical brake on the Z-axis of CNC machines. Other clients use it to mount a handwheel, so the CNC machines can also be manually adjusted. (we would not advise doing this, an electronic handwheel(pendant) is a beter solution. Basicly this type of motor is used, when you need to be able to mount something on the front and back of the motor. We advise to use this motor with a DM2282 driver. Its possible to use it also with EM882S driver and 75VDC (at least), the RPM range is very limited when you use in that way.

Component features:

• Holding Torque: 12.0 Nm
• Frame Size: NEMA 34
• Step angle: 1,8 degrees (200 steps/revolution in full step mode)
• Type: 2phase bipolar steppermotor
• Degree of Protection: None (motor is not water or dust proof)
• Termination type: 4 wires
• High performance steppermotors selected for our range of stepperdrivers
• Low self-inductance, less back EMF, allows higher RPM from same framesize
• Available in 2Nm, 4.5Nm and 12Nm